Chinese   | English TEL:+ 86-18660665609
About us

Light word technology and processes

The following describes the general method of production, or that sentence, simply look at the video to watch the video do not do it yourself.
A, Wai border. In the glass around the rectangular frame, the length of more than 1 meter, the width of the number you want to determine, usually a 5mm width, and consider the loss. Around the border material glass, wood, the market has to sell the sponge adhesive strip, the contact glass side with double-sided adhesive paste to prevent resin pouring outflow. The best contact surface box with a good double-sided adhesive (leaving the contact surface is not torn)
B, in the box glass surface waxing, bright paint.
C, deployment of resin, according to each 1m long, 5mm wide, 4mm thick, according to experience, the weight of the resin is about 200g said well.
D, the total amount of 1/3 add pigment paste, stir well, according to the ratio of adding blue water, white water (with a little)
E, pouring back and forth in the box, catch up and let it flow naturally. After 30-50 minutes and then configure the remaining resin in proportion and pour into the box flow level.
F, Tiled surface mat above, to enhance edge toughness and strength, but may not
G, 2 hours later, the demolition of the box, according to the requirements with a blade into a strip.
H, Foam adhesive tape according to the font line around, and then just make the resin edge up close to the adhesive edge. Of course, after the next strip of resin, double-sided adhesive with the lower edge of the strip.
I, Wai, the deployment of resin, also take 1/3 to add the same proportion of pigment paste, pouring positive, 30-50 minutes after pouring again

Address: Hanting High-Tech Industrial Park, Democratic Street, Beihai Road, Weifang City, Shandong Province 7A

Mobile: + 86-18660665609

E-mail: drive_me@126.com

Links: bending machine   
Copyright © 2014-2019,DRIVECNC, All Rights Reserved